AudioScience Dante Iyo firmware
- aes67: bug fix for exception on TX flow deletion
- Support added for ASI32xx models
- Unreleased build
- dante: add support for changing the sample rate without requiring a reboot
- dante: add support for Brooklyn 3 module (4.2.4.8 firmware)
- hwio: porting for BN3
- webui: implement individual channel naming, tied to Dante tx/rx label
- hwio / py: add marvell detection check
- lw:rp: implement individual GPO control
- lw:rp: GPIO bugfixes
- AES67: fix enable flag status
- webui: GPIO tab style changes
- lw:rp: Implement individual GPO control
- hwio: fix for AES67 mode inadvertently persisting
- xmos: update XMOS firmware to support A-suffix parts
- build changes: zip archive upload fix
- build changes: upload directory path and creates zip of output files
- wasp: set password to disabled by default
- same as 3.5.5 but disabled io count test (hanging Travis)
- same as 3.5.4 but built on master branch
- note: not built on master branch
- asi27xx: enable ui password with disable
- hwio: reduce unmute delay to 100ms after toggling phantom
- wasp: update WASP conf files to WASP version 3.2.0
- wasp: support X-Wasp-Stream-Min-Update-Period and X-Wasp-Stream-Exclude-Obj-Type headers
- dante: fix Dante device prefix names for some models
- dante: support 88.2kHz sample rate
- audinate: update brooklyn II firmware from 4.0.9.1 to 4.2.0.28
- UI: flash meter LED red when phantom is on; cycle between red and blue when both phantom and mute are on
- UI: always cycle through the complete identify LED identify sequence
- oem: OEM specific changes
- py lw: further bug fixes for Pathfinder PC/Pro
- py lw: fixes for Pathfinder PC/Pro
- py lw: implement Livewire GPIO
- webui: add GPIO interface (RJ-45 models)
- webui: modify AES67 interface to allow specific transport IP addresses
- py lw: advertisement bugfix
- wasp: implement bulk patch support as spcified in version 2.1.0
- webui: remove non-applicable menu options from Input only and Output models
- hwio/webui: add output mute
- conf: added OEM configuration
- hwio: keep SYS led orange until objects restore is complete
- hwio: cycle input meter LEDs blue when muted
- py: unit test fixes (e.g. property validation)
- config: define Product Version
- hwio/web-ui: add temperature sensor
- hwio: bug fix for mic pre levels +5 to +10 dBu
- web-ui: display gain in dB instead of level in dBu on inputs
- http: support method overriding
- hwio/web-ui: bypass pad on input levels of 0 to +10dBu
- web-ui: add Settings tab with LED Brightness option
- models: add ASI2705, ASI2706, ASI2708, ASI2709 (16.0M, 32.0M, 0.16L, 0.32L)
- web-ui: disable phantom power button when pad is engaged
- web-ui: add AES67 streaming feature